Cant generate .dll and .lib files

[axv4444]

I've done the steps 1-7 under

Build Instructions to create LAPACK and LAPACKE 3.5.0 dlls for Windows with MinGW

at

http://icl.cs.utk.edu/lapack-for-window ... k/#lapacke

but the next steps I cannot understand them. Sum1 plz tell me how to do the next steps and plz give a detailed explanation about it. Specifically the cmd prompt part:

i'm typing

cd E/LAPACK 3.5.0 >Enter

C:/MinGW/bin/mingw32-make.exe >Enter

but i'm getting

mingw32-make.exe> No targets specified and no make file found. Stop.

[admin]

I think you go to the wrong folder.

cd E/LAPACK 3.5.0 >Enter

You need to go to the folder where CMAKE generated the code...and then type mingw32-make.exe
Hope it helps
Julie

[axv4444]

I did the same thing but i'm getting an error.
Sir can u plz tell me the entire part of the command prompt onwards in precise detail?

E:\lapack 3.5 is my folder in which I built the cmake destination code. What do I do after that in the command prompt?

[admin]

Could you tell me what are the 2 directories you are using?
- The source directory : "Where is the source"
- The build directly: "Where to build the libraries"

What was the output of the Configure? It should be "Configuration done"
What was the output of the Generate? It should be "Generating done"

When you go to your build directory, you should have a file named: "Makefile"
Can you see it?
If you do not have a Makefile file, I see two reasons:
- either you are not in your build directory
- either the Generate phase was not successful

Hope it helps
Julie